Activity Stream

Hi, My brother and I started "self learning" on a 1968 el camino in 1974. Drag racing since early 1980's (carburetors only). I build fuel...

The Neural Network FAQ explains this in the "Do I really need to modify all 25 VE tables for FCA vehicles?" section. ...

^Thanks! For the last couple days I've been rolling around with these settings: I don't notice any adverse effects yet, just great highway...

the compression is 9.8:1 so that sounds about right maybe a little high but if you have the octane for it its fine.

He?s going to check the next time the truck is brought in, if he remembers that is lol. The customer isn?t complaining about it though.

100% what murfie said, had the exact same issue with a 2016 Procharger stage 2 car. I was chasing my tail for like 3 days straight then put...

Subscribed.

I'll do that, thanks for the direction!!

Here's HPTuners version 335. I grabbed it off emotion's beta site before the site came down. It's the latest that they publicly posted. I've seen...

I'm just getting started with HPtuners, I have a 2010 426 CI with a maggie, It has a Diablo tune in it now, will I be able to read and edit the...

There's an 05 since 06 has already been posted

I'm running a Comp 268THR13 214/233 113lsa with a phase limiter in my 5.7 and had no luck with ANN on. Truned off ANN, Dialed VE, idle rpm,...

I would email support and ask. Maybe they have it listed wrong and should of been 14-19 instead of just 14. I have no experience with 3.2 vehicles.

In the latest VCM Scanner Beta, there will be a v3.1.4 or later firmware update via Help -> Resync Interface, and then there's also a Vehicle ->...

You can just write entire the 05 PCM with a 06 file. Will cost credits. I have some 06 53 L33 files if you need one. They are in Tunercat format but...

My apologies for not being more specific. My question arose after reading that list. I have a 2018 Jeep Cherokee with the 3.2 V6 but only the 2014...

16:1 or close to it. Downside is potential hesitation or even misfire if it gets lean enough.

thank you. i will look into that

Thank you the input! I will check/add what I can :)

What are the downsides to doing this? Do you know what this approximately equates to for AFR? Thanks in advance!

Most of the cams I tune, I turn ANN off

I don?t have the truck, no where near it, would have to talk to the guy I did the tune for to see if he?s got anything to check that.

Must be from a different module. Do you have an aftermarket scan tool that will display mode 10? Those are the permanent codes I was talking about....

There are no codes being displayed, everything to do with the EGR, DPF, DEF and warnings is turned off via the disable switches in the ECM.

Need a little more info. Did you scan and see what codes it is displaying? May be a "permanent". DEF issues have many permanent codes.

opens fine for me