Activity Stream

could having those vales higher effect/ skew when it goes into power enrichment?

now that the CORE has been released i would expect less and less upgrades here even for the GMC friendly stuff. nothing wrong with dreaming...

Awesome, yeah, the ELM327 is the chip. I think it's an atmega processor with the industry standard diagnostic protocol on it. I forget the name. I...

here is a later challenger for compare

Took it for a drive. Stalls after it starts moving. Please note this is running with some e85.

Just some of my own thoughts and findings over the years on the programmer upgrade stuff. I don't have a ton of experience with it (I'm not a pro...

I mean you have to press on the gas more for it to downshift. You need to hit ~90% throttle at 40mph to do a 4-3 downshift vs ~70% throttle in the...

FILTERING DFCO (I got working) I experimented with DFCO and set my filter to discard data with Injector Pulse Width under 2.0ms. Oddly it did nothing...

Agreed!

Its gonna have to be tuned once the mods start comin. Its nice that yours has a stable idle. Where does it fall in the line above in terms of...

I left my "tune", any thoughts

Since I'm new to all this ECM and tuning, how do I tell if I have a valid VSS (vehicle speed sensor) input. If I drive the car in scanner mode and if...

I don’t have the ability to ban or suspend him or I would have already between that post and the PM’s I’ve gotten. Bill or Keith will have to do...

Looks like i accidentally calculated the pushback ratio. :yay: Yes, so far Max Aircharge Clip is driving the curve in the linear...

Commanded EQ and EQ in that log look ok.. prehaps lean for that ECT.

Yes,rest of the truck is stock.

Are you talking about the .50? I think that is the gauge rebooting after the restart. AEM takes a 5-6 seconds to boot up. I had STFT Open Loop...

Does this mean that the MAF transfer function must be dialed in before logging Air Load for SD tuning? If someone made changes to the MAF house size...

ill have to check out the repository, didnt even think of that. lazier to down shift - as in it will hold onto the gear longer? or it will shift...

YUP, my new cams are made by Kelford Cams, and we use beehive springs and titanium retainers also by Kelford Cams for the best acceleration in an sc...

for logging the two in the vcm scanner was trying to figure out how to log them the best way to be the most helpful

Have you checked the supported vehicle list? Toyota's are pretty thin.

Make sure you click the alert button in his post. That way the mods are sure to see it.

Is this the cam specs? 212/218 .553/.553 111+0

Yes iv been read a lot on here,and have the idle pretty good now,right around 850 is where she seem happies,still play with the timing and fuel.

It's likely there's other values that need set to get this working (that are not defined in HPT). It looks like its cycling between cmb mode 0 (DI 1...

But I agree with the discussion here either way. Surely the data is coming in as 0, 1, 2 etc. and being converted to display as something more human...