Activity Stream

I tried Alvin's tune with BTM disabled and got the same result. I've attached the original calibration and the most recent log. Fuel pressure really...

Will do, thanks. Just ordered the MPVI3, 6 Credits and a Dodge 2018+ Smart Access cable...... $811.49 Will be purchasing new Dodge PCM/ECM once I...

The transmission settings have a bunch of changes from stock, and many of them make no sense for your truck. However, those can be fine tuned back...

While driving, no. It drives pretty smooth so far. There is a little surging in idle/park and a little in drive. Do a quick blip of the throttle it...

you cannot write someone else’s file to your controller

I'm not sure how low the temperature has to be for this cold shift schedule to activate, but once I hit a TFT of 68F my truck starts using the base...

Honestly probably too short of log to tell anything. The exhaust leak is way worse than I thought. The manifold basically isn't even hooked up. I...

Thanks for the input. I’ll make some adjustments and report back.

Like ed pointed out, there's throttle adjustment and VE. Also, there's the way idle spark maps are setup. For idle spark need smoother transitions...

yes the problem is returning to idle and having idle to stabilize without surging like it is. the actual idle itself is fine. Its when you blip the...

I will try that . I spent so much time on this VE doing it this way uggh. I agree there are a few rich spots I will see if I can figure out how to do...

I ran the BFD cam in my 05 rcsb Silverado with 2800 stall for a solid year only adding the cheap 4 hole injectors and ditching the stock 2 hole...

It's usually one of the RPM limiters at the top of the page. InGear, EOT, Wheel Speed limit. The EOT and Wheel Speed I always set to like 8000 right...

No, the goal is correct "return to idle" behavior. Which is different than a smoother idle. The fix for the return to idle problem is the combination...

.hpt is our file format from an MPVI device using our vcm editor software. Yes you'll need to provide us with your vehicles .hpt file when...

Even with wideband I think the VE table could be a bit more accurate. Give CL a try and you'll see.

Build another windows 10 laptop : )

ok I was using afr error. Is that not a good method?

Anything in particular you notice while driving?

cold start to temp with drive to shop. one WOT passing a car

The VE table needs help. Re-enable CL and re-tune VE using trims.

Many thanks, this is a big help! :hi:

lol ok guys didnt want to start trouble and have a pissing match. I am willing to try any methods . As I stated before Im inclined to think its a...