Activity Stream

Hello everyone, please tell me, in my firmware there is a parameter: 46950 - TCC Performance Mode Maximum Gear: The maximum gear allowed to...

Does anyone know if the signal expected is; 0 volts = 0% ethanol 1 volt = 20% ethanol 2 volts = 40% ethanol 3 volts = 60% ethanol 4 volts = 80%...

I would have thought pin 6 on the X4 connector is the ethanol input and pins 5 and 16 on the Fuel pump power module are for your GND & +12v.

My 2003 ECSB 5.3L truck needed a 4.30 gear, 3,600 rpm converter on 28" tall drag radials to run strong with the STOCK cam. With the stock converter...

I love mine. I would rather have a good converter than deeper gears in a state with 80-85 mph speed limits. Converter can be locked up in 2nd gear at...

Yay. It'd be nice if you could share those settings so others may benefit.

Idk what more i can say. It ran like a beast one time even with wrong injector data ripping 2nd gear burnout down to 2500rpm prooving that my setup...

I have done the reset/relearn through vm scanner along with unplugging the battery multiple times. Have not looked into any RF/EM interference at...

The file is Tooner Locked.

So what do I need to do?

Okay, I will start with stock Vt tables and work our way up. I have had other boosted cars with Vt in the realm of this car and not have this code,...

If you are trying to log to the MPVI3 without a computer connected, I think it is still broken. I gave up and I now log to an AiM XLog. I find the...

Have you looked into RFI/EMI or trying to shield the throttle wires? Or tried a throttle relearn?

Just because the axis ends at 7500 doesnt mean it will stop there. It will stay at 24 7500+. No probably not

What did you figure out on the cruise control?

Thanks Guys I've been a member here for about 15 years but seldom make post or send attachments. It seems I can attach the .hpt file but not the...

might be the idler off the stator looks to be on the 8 speeds and 10 speeds https://www.youtube.com/shorts/zk-Snj-pqic

Ive attached my tune file for my 408 in SD. hopfully it will be of use

I'm probably not the guy but.. Looks like that's a LOT of fuel. Long terms are at -9 to -25 short terms are in the -8 range. I only have some...

Hey Hyperbolecubed, Any recommendations on a knock sensor? Here's my build sheet: Engine/Trans: Clegg Engs. stage 2 4.6 stroker kit w/...

09's are funny that way, and the early production 1500s and some of the 6M challengers NN is not even activated, there was a dealer Update for those....

I added a few more channels and recorded some logs (before starting). first log: sitting, doing nothing, then pressing the throttle to 100 a few...

Btw I ordered a couple of IAC drivers just for the fun of it. My Current P59 PCM is a (Blue/Green) 12589463 (no AIC driver) w/HDW 12589162. Any...

even if want it to at least handle to 7600 rpm to get straight graph wouldn't adjusting cam timing perform better? what about adding long tube cat...

Reprogram the ecm outside of HPT (AC Delco TDS) for a manual transmission vehicle.

Ill try that when i get back to the shop Friday. It really can be the only thing right? taking that much fuel out of the VE table should cause major...