Activity Stream

File a dispute with Paypal. They are pretty good about siding with the buyer.

Update, the customer's truck is running the 66RFE without ratio error codes. Selected 66RFE in the drop down and changed the ratio parameters to...

Just so you know, we have successfully swapped a 66RFE in place of a 545 now. It works, just need to change the gear ratio parameters and it is happy.

Thank you for the clarification.

Hello to all. My name is Joe. I came onto HP Tuners Bulletin Board for advise/help, hoping to find some. Instead, I got Don Tanklage, a self...

Dynamic disable @ 400 = 'MAF only'. Below the Dynamic disable, it's in blended mode - a mix of both MAF and VE through some crazy equation. Above...

Could be the fuel system is on the very edge. Assuming its stock fuel rails. Considering where each cylinder is, this would make sense. Furthest...

Yes sir. Been down in the dumps this weekend and didn?t get to do much. I work night shift and will be going back in in about 2 hours.

So you did some of the things and didn't find a problem?

Well I finally done a compression test and all is good. 170-180 across the board. Fuel pressure is 58-60psi at idle and going down the road with...

I forgot to add I do have a 180 degree thermostat. Though, I think I've figured out what to set the fan on/off temps to from another thread.

I added all of the settings mentioned I believe and here is a log when its driving good, and 2 others where it is retarding the timing. Seems to be...

Issue occurs at 1min 25sec in the log.......pressing accellerator pedal, engine stumbles. Another example is at 2min 50.579sec.

I have a log and tune to post from last fall regarding the issues I still have with tip in hesitation. Thanks GHuggins for your prior efforts. That...

Has your pc updated around the time the issue started? Have you tried deleting the PID then reloading it and polling for new parameters?

The stock file is in the first thread of my post: 2019-GS-Manual-Stock-Read.hpt

Im sorry, but what is the BRAF? And could you explain the dynamic and MAF only? the only tab i see that has a dynamic subtab is under airflow, and...

thanks. i didn't know that they used the stock ETC scalar. Good to know. I know that sometimes the new ones don't play nice with the c5's but i had...

Just the first one, I didn't realize it didn't have it my bad. I never use anything other than pump gas so I will turn the virtual flex off I guess?...

Running 87 and always have, I just filled it yesterday and decided to use Mobil rather than the grocery store gas I usually do..