Activity Stream

Yes, something is wrong with the wiring or unpluged. 450 is what they read unplugged

There is so much wrong with that tune I'd start completely over. As long as it's not black smoke rich or spark knocking it should be "safe" to...

I've never and I do not know of any other professional tuners that copy any idle settings out of another car. Well other than hardware stuff. Like...

Cracked spark plug or wire not snapped on fully. One or the other or both.

Misfires and knock retard are totally different. When is it misfiring? Is it limited to one cylinder? How different a heat range is the new plugs...

That combo will last you for years!

The MAP sensor characteristic fields are for telling the PCM what sensor you are using, so you enter the proper values based on the specifications of...

L83, Texas speed stage 2 truck cam, forged bottom, Holley high ram, lt5 throttle body. Was very simple

No problem. Post the tune and log. Here's a good one to go through: https://forum.hptuners.com/showthread.php?110027-Tuning-help

Nah I don't think you touched cam angles. Again, my mistake. If you flatline VCP it will help a lot to do like I mentioned with the cam angles. ...

Your MAP sensor characteristics for the Mopar 3 bar should be: MAP Sensor Linear: 61.05 kPa MAP Sensor Offset: 7.0 kPa MAP Sensor Offset: 0.1001...

There are a few SEP 1000cc class listed for GM applications. Go to their website and find the one that matches yours.

Haha that's because I typed 15248 smh. The 15284 is for 2003-2005. 02, which is the VIN and more importantly OS, is the part you need. Denso over...

how did you buy the interface and the credits ???

@SiriusC1024 Verified sep 1000cc IAT in in intake/charge pipe about 6” from the tb and just after the blow off valve

Wound up buying the DSX aux pump and it is performing wonderfully. Took a bit of trial and error to get the pressure to act right but it is doing...

Yeah it just shows you can't just pick out a piece of another engines tune, plug it into another tune and expect it to work properly because like you...

Have checked the fluid level of the trans? The come low from the factory..

well shoot, it just plugged in!! I went ahead and pulled them both out for a sanity check, but now im not sure what the parts monkey at O'Reilly's...

Get a pair of Denso's for your ECU. It'll work out better for a couple reasons. Fix the wiring of course.

ok, took it for a few laps around the block and let it come up to temp. died on me several times, but you are right, O2 sensors are flatlined. I had...

The Denso is correct (cross-reference P/N is 2344650). The Bosch doesn't belong in there (15896 is called for). How'd you do that? It's a...

I tried submitting a ticket and they told me they do not help with tuning and simply said go to ford and get the latest flash and from what I can...

ok, ill try the tune, im running two different O2 sensors, donor engine only came with one. . . . . probably a mistake :doh: one is a Denso 12562943...

Shoot me a msg, i can help via sct or hpt

Fair bit more work to do on VE, but looks like progress. Interesting that dynair isn't available.