Activity Stream

I've been back and forth a few times with the HP Tuners support. They recommended I try a bench harness to try and read the tune off the ECU. I tried...

If you read the description for Brake Torque Management setting its kinda backwards from what you think. If you want to disable BTM when you turn...

hi, why dont you tell us a about your set up, goals, and what games you have been playing? We cant tell you anything without any input from you. ...

I updated firmware before I did the initial read. I think I figured it out. I was flashing on the road, via my phones Hotspot. I believe I am near...

Yep, confirmed my '21 Ecoboost reads and writes just fine. No hiccups so far with the Beta.

It is possible that HPtuners does not have a read from that particular ECU. What is the part number on the front of it? 401xxxx?

I assume you are talking about fields 3003 and 3033. If so, 4000 and 3900 RPM are the desired settings (which is OEM stock). Typically tuners will...

Well an update. Took trans out Saturday and found a leaking front Torque converter fluid seal. Output shaft seal was leaking too, but I didnt replace...

Try these. I would also suggest looking at your VVE airflow and Fuel Injector IPW valves when this happens.

Try this. You will probably have to click (and hold for 8 seconds) the traction control button.

https://www.youtube.com/watch?v=mAr1hhSGjJQ&t=127s

Copy on the afr gauge. I have one sitting now, wish Id have seen your post sooner, much appreciate the work, I havent programmed a microcontroller...

Yeah i talked to tech support last year but honestly its a huge PITA for me because i am not around the ski during the week when TS is there so since...

He lives about 45 min from me. I havent met him in person, but we spoke in private messages a bit when he first started tuning. Im hoping i run into...

It was super nice to just grab the canned profile in channels and plug it up, though. I need to quit being lazy��

Ok, Thats the conclusion Im coming to as well. Tech support know its an issue, I was told it was in the queue so to speak. Any issues with...

All of the horsepowers lol

Do you just need bigger injectors or whats the issues with the current ones? whats the vehicles/engine combo? Cam specs what intake are you...

This isn't our tune. this is just what is needed to get the 4l80 going. Is the wiring all stock? The wiring for VSS are normally a twisted pair...

It will not shift if the VSS is still not working. It shifts by speed. It must have VSS.

You should post the tune and a datalog of it trying to start. Perhaps we can see something you are not and get you on the way.

It's connected directly to the can output of the spartan and then hooked to the can bus of the ski. The board has two can bus circuits one for each...

Have you update the MAP sensor(2/3 Bar)? If so, we need the part number. Heres some basic channels to log... Vehicle speed RPM MAP MAF (if...

When your wheel speed goes to zero (looks like sensor issue) Your rev limiter is set to 5k.

Hi! I have a 4.6L with a mild cam. I would appreciate if you share your tune file, thanks

Also the roush base would be mint!

You can relieve some pressure at the fuel rail with the shrader valve. if it starts immediately after that it was likely vapor lock. If you have...