Activity Stream

Same issue on and off even replaced the throttle body still if I command 100% my throttles 73-74% open no luck tried driver demand-virtual...

Probably a box code that isn't supported and has no stock file to downloaded? Can't say for sure but likely you'll need to create a ticket to have...

B9 A4 is Simos 18.4 or am I thinking of something else? Which is not supported last I heard. But within the realm of what's possible based on how...

I did find that they ran the 2.8/8L90 in the 2017 2500 Express vans, so the trans is out there. They run the same E98PCM/T87(I'm guessing A) TCM. My...

Heard the injector seal is possibility I never had issues with them being stuck in the heads I’ve inspected them and cleaned the injector tips and...

I switched to Amsoil and have not had any issues with phaser rattle. Cold flow is far superior to most of the other oils on the market, which is what...

I think that Kevin is right. From what I have seen, one tuner even found a bit of power on an L92 by reducing the full throttle retard at 5500 1...

Hello All, New to tuning and recently did a write calibration to a copperhead ECU without first disabling P0605. What needs to be done now to turn...

Okay, thank you! Those values sound like a lot of retard for lower RPM and low load. I read somewhere retarding reduces manifold vacuum which can...

2014 buick lacrosse LFX engine E39a ecu, will this work?

Anyone have a newer 2.0t file from an A4 is might look at, stock is fine?????

I see lots of other tuning options for the B9 platform, so I'd hope HPT is on the boat too. I plan to test drive one and see if I can pull own...

I am using the L96 injectors and intake manifold. The only hardware changes are I am using the stock 2009 1500 exhaust manifold, cold air intake,...

Downloaded from where?

The number that you see in the table is how many degrees of retard that is commanded. That table shows to have up to 28 degrees of cam retard...

This limit is in eeprom, not in flash...found that hard way

As far as I know they will be supported as same box as most of the Flex fuel 13+ cars

Are you running the L96 injectors? It's certainly adding a good amount of fuel across the board.

The gain value is what I take to be a close estimate of the boost ratio of the valve from signal pressure to line pressure. I.e Feed it 400kPa x...

did you make progress on this? I have basically the exact same issue. ...

If still needed any data I have it. They work excellent been on my car 2 years now. Car drives great with big cam and tons of work done.