Activity Stream

Not at all, I have seen 3.5-4:1 briefly on stock GM tuned vehicles in 0F weather during cranking.

I see you cracked some other 2024 models. Any news on the Raptor R?

“Will work” and “should be done” are two different things. I know of at least two major tuners who leave the torque tables stock. Should it be done...

Yes.

At that point, a window pops up that says "turn ignition off wait 10 seconds and turn back on." However, lately it's been popping UNDER instead of...

I hadn't really thought about it too much, but it sounds like I may need to look into a fuel pump upgrade with the injectors. Would I confirm this...

19418810 supersedes 12615136. https://www.newgmparts.com/oem-parts/gm-barometric-pressure-sensor-19418810 The values for this are 200/8. Use...

https://aka.ms/dotnet/8.0/windowsdesktop-runtime-win-x64.exe

What I have for an IAT curve is very close to what you came up with.

Welcome.. you'll notice this side is mostly a ghost town now days compared to the GM section. I think there is a thread in the EEC-V section that has...

No problem

map sensor is a 19418810 ac delco. have the iat in the charge pipe after the intercooler. had the offset at 9 kpa but it was reading 106 kpa koeo....

Awesome thank you

Unless you're running very low boost. Absolutely no.

i dont see any underlying issues mechanically. pulling plugs/replacing, checking compression and checking everything else shortly. This is a new...

0kPa for values to the other columns of injector offset. .243 for Min PW like default .243 value. Fuel>Transient>Min Fuel Mg to .008. ...

Check yer messages

op did not mention anything about limp mode

You disable/zero bias the cylinder charge complex temp model when installing the IAT in the manifold. The stock GM unit responds pretty quickly, but...

I think I see where this is headed...

Event with the generic tune from hptuner you can remove the rev delay over 2500rpm

Either blast it with a super excess amount fuel in the FA1 table, or fix the EOIT timing to more closely spray at PPV.

I'm interested in seeing what the VE table looks like with the ls3 adapted.

thx, yeah that is exactly how to export now how to figure out the bucket part of it lol

Well a 2010 engine is likely to have VVT. What did you do about the VVT??