Activity Stream

All those pids and you're missing the most important one for this problem. Injector on time.

If youre going to use fuel trims to drive the vehicle around after its tuned, then use the fuel trims to correct fueling table(s) and MAF table. (as...

If only there was a forum dedicated to welding questions.... https://www.weldingweb.com/

Thanks that's the reply I was looking for. So the wide band isn't good enough for tuning down low only up top? I did take out one of the o2 for the...

Before worrying so much about the drivability it might make sense to get the everything squared away with the engine side, there has been alot of...

You seem to be correct. Went to 66-6700 the tcc slip was lesser as the rpm.went up

i completely agreed i was aware of those gear ratio change but as i mention earlier the in first with the 80e it feel like a dig in second with the...

Welcome, Tuned with what ? Diablo ? Have you Set octane tune ? Undo that. Have you reset the fueling? If there was an issue with a lifter, the...

Cool, thanks. Good to know MPVI3 reads and writes now. I did a PCM swap last year for my 24 Australia market Ranger Raptor and been tuning with...

Interesting, I have a second trans so Im gonna check and see if it needs to be swapped over

Just did 4th...all good. OS is nothing new,hpt had those defined for a while including Dark Horse. OS is based on 21-23 F150 with few changes for...

Never realized the blessing of owning a 1996 mobile home until this thread. Doesnt hurt that i live on a mile long stretch of junk and run down...

No, I did not touch the throttle until it had been running for nearly a minute; had to move it to a different parking spot.

You should email me. This is not the right approach. Your CP3 has more overhead than you realize. [email protected]

No one can help you if you don't post your tune and log files.

Need Beta to read

These VVE edits should help throttle response.

I tried to read mine today, but I am getting an issue with the file read. Hopefully I can get it cleared up soon! Thanks for posting, that's what I...

Hello Name is Dustin CAR Med Retired Marine. I own a 2008 Cadillac Escalade ESV . I recently stuffed a stage 3 CAM and removed the Cam Phazer,...

The ramp torque tables; Yours are real mild. Try doubling the rightmost 2 columns in the 1-2, 2-3, 3-4. For example, the 1-2 will be the 1350 and...

Are all new MPVI3 devices shipped with this firmware installed, or does anyone who wants to tune EECV vehicles need to go through the firmware update...

Has codes P1DF3 and U1428. makes sense I guess. tune Attached.

I agree with RobZL1 and with the tools from Cringer for MAF & VVE, it's a relatively quick process :) 1) I found the easiest way to adjust the...