Activity Stream - HP Tuners Bulletin Board

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

21 Minutes Ago

DrLoch replied to a thread VCM scanner not reading DTC or Emissions readiness in VCM Scanner

I have the same issue on one of my laptops. Hopefully we are both able to learn from the same question

1 replies | 43 view(s)

1 Hour Ago

Z0Tex started a thread Wanted: 2019-2020 Camaro SS M6 Stock Read/Tune in GM V8 Tuning - Engine, Gas (Gen 5)

Would anyone have a stock read/tune from a 2019 or 2020 Camaro SS with a manual trans? I have a stock tune from a 2019 SS with an auto, but I want to...

0 replies | 1 view(s)

1 Hour Ago

1970ss8.1 replied to a thread 2.0 tfsi in Audi/VW

I?ll do that. I?m just waiting for HP to get back to me.

53 replies | 661 view(s)

1 Hour Ago

str8dum1 started a thread torque priorities while tuning VTT in GM V8 Tuning - Engine, Gas (Gen 5)

I am trying to narrow down why my throttle is closing. So we have 3 torque PIDS that seem to be important. We have Peak engine trq, predicted...

0 replies | 5 view(s)

1 Hour Ago

TylerJDubbs replied to a thread 2.0 tfsi in Audi/VW

And also there’s a lot to learn from just logging the car stock under different conditions. Then referencing the binary to find where the ECU is...

53 replies | 661 view(s)

1 Hour Ago

veeefour replied to a thread 15+ F150 incorrect Engine Indicated Torque Reference in Ford Tuning - Engine, Gas (Non Ecoboost, US)

I have those turbo tunes done like 95% drives like stock but once in a while I have that "detonation tip in limit" in torque source at WOT - mostly...

14 replies | 228 view(s)

2 Hours Ago

WAK replied to a thread 2010 E38 LS3 Reduce below Idle Push in a Manual Trans Car in GM V8 Tuning - Engine, Gas (Gen 4)

Your over looking a few things. The high idle after start up is an easy fix. There is "start up" air flow, you can adjust it based on time and engine...

7 replies | 81 view(s)

2 Hours Ago

mohd replied to a thread HD 3500 6.6L diesel problem after reflash in GM V8 Tuning - Engine, Diesel

Any hints.

1 replies | 25 view(s)

2 Hours Ago

10_SS replied to a thread 2010 E38 LS3 Reduce below Idle Push in a Manual Trans Car in GM V8 Tuning - Engine, Gas (Gen 4)

thanks, I had Spark basically disabled long ago. I started looking at that idle torque table, and ended up 0'ing every table related to idle...

7 replies | 81 view(s)

2 Hours Ago

Xsen started a thread Real MBT spark table in Dodge Tuning - Engine, Gas

Hi, Does anyone know where the true MBT map is located in Dodge ECU? I'm looking at the map that is under Spark>Advance>MBT>Base vs...

0 replies | 12 view(s)

2 Hours Ago

welder350fd started a thread 2011 Caprice 6l80 Converter in GM V8 Tuning - Transmission

I have a 2011 caprice PPV with 43k on the clock. Recently did a cam swap/DOD delete. The car runs fine (still some tweaks to make), but I am...

0 replies | 12 view(s)

3 Hours Ago

crash01 replied to a thread Where did the EGR maps go? in Ford Tuning - Engine, Diesel

this wouldnt be such an issue if we could import .bin files without issue, but yes i agree with you, to do a legit emission on tune we need to...

11 replies | 175 view(s)

3 Hours Ago

Speey_Mikey started a thread Logging inferred/virtual fuel composition ?? in GM V8 Tuning - Engine, Gas (Gen 4)

I'm noticing in my logs the spark advance is always 5-12* higher than what the high octane table says it should be. My hunch is the computer is...

0 replies | 13 view(s)

3 Hours Ago

sevinn replied to a thread launch control TWO STEP CTS V 2012 in GM V8 Tuning - Engine, Gas (Gen 4)

You cannot on an automatic car.

2 replies | 32 view(s)

3 Hours Ago

WAK replied to a thread 2010 E38 LS3 Reduce below Idle Push in a Manual Trans Car in GM V8 Tuning - Engine, Gas (Gen 4)

https://vcmstore.com.au/blogs/news/gen-iv-e38-e67-idle-control Check out this page. Some good info that might help you make the adjustments you...

7 replies | 81 view(s)

3 Hours Ago

CCS86 replied to a thread NGauge SD card firmware missing in Ford Tuning - Engine, Gas (Non Ecoboost, US)

Download that firmware and put it on the SD card using your computer.

7 replies | 1172 view(s)

3 Hours Ago

richhurley replied to a thread Dodge Emissions Question in Dodge Tuning - Engine, Gas

Replaced mine with OEM sensors.

17 replies | 1950 view(s)

3 Hours Ago

Madcat. started a thread pop blow, shooting exhaust. E80 Camaro 2.0 LTG in GM L4, I5, I6 Tuning - Engine

Is anyone do it on Сamaro 2.0? Maybe have some video?

0 replies | 7 view(s)

3 Hours Ago

BackyardTurbo_FTW replied to a thread Optimum Torque 32900 and Torque to Load 32850 Issues in Mercedes

Also, if you go in Engine Diagnostics you can set all of the timers to take forever to kick it into reduced power mode ;)

3 replies | 45 view(s)

3 Hours Ago

spoolboy replied to a thread 8HP70 TCC Lockup for Launch in Dodge Tuning - Transmission

It's OSS rpm, so it is unlocked for a bit until you get under way. Mine doesn't seem to follow the map. I must be missing something. I'm logging...

1 replies | 29 view(s)

4 Hours Ago

MRRPMBRP replied to a thread 15+ F150 incorrect Engine Indicated Torque Reference in Ford Tuning - Engine, Gas (Non Ecoboost, US)

Maybe we're off topic, but we may find something here. I bought my GT500 used, the SIP sensor was just laying on the manifold, so it's just...

14 replies | 228 view(s)

4 Hours Ago

JaegerWrenching replied to a thread New hp tuner user in Ford Tuning - Transmission

1A-2M is for shifting under 3 or 4 mph if i remember correctly. Therefore it is of no use when looking to firm up WOT shifting because you'd be past...

4 replies | 261 view(s)

4 Hours Ago

Shane Hewitt replied to a thread 2016 GMC SIERRA KR* can't eliminate in GM V8 Tuning - Engine, Gas (Gen 5)

As an experiment, richen it back up some. If you're actual air/fuel ratios are in the ballpark of what you're commanding, my experience with LS...

6 replies | 216 view(s)

8 Hours Ago

starglitch replied to a thread NGauge SD card firmware missing in Ford Tuning - Engine, Gas (Non Ecoboost, US)

firmware 278.ng was not found on the sd card check filename usb sd card active bios 40/fw 278 sn 33983 hpt need help to get it working

7 replies | 1172 view(s)

9 Hours Ago

murfie replied to a thread 15+ F150 incorrect Engine Indicated Torque Reference in Ford Tuning - Engine, Gas (Non Ecoboost, US)

No I was talking about the barometric learning max and min. .44 bar would only be average at an elevation of 17000-18000 ft. It drops about...

14 replies | 228 view(s)

10 Hours Ago

veeefour replied to a thread MVPI2 Expander Hub in VCM Suite Product Info

Will Expander Hub ever come to fruition? I need more than 2 inputs already.

3 replies | 1178 view(s)

10 Hours Ago

alfa5252 started a thread Looking for a Stock 2008 VE Calais LY7 3.6 V6 5 Speed Auto Tune File in GM V6 Tuning - Engine

Would anyone be able to send me a standard tune file for this LY7 engine? I had the car tuned by someone and am wanting to return it to stock as it...

0 replies | 11 view(s)

11 Hours Ago

veeefour replied to a thread 15+ F150 incorrect Engine Indicated Torque Reference in Ford Tuning - Engine, Gas (Non Ecoboost, US)

On how much this can be learned - I believe you mean this. It can range form 150 to 400%. Reducing it helps with oscillations as mentioned but it's...

14 replies | 228 view(s)

11 Hours Ago

Jim P replied to a thread Importing EFILive file in Dodge Tuning - Engine, Diesel

Chances are it?s a no

1 replies | 24 view(s)