Activity Stream

use the 'go advanced' button and upload the tune and datalog

Okay, no start but cranks, no 12v signal out of the pcm @ pin 2 blue, checked and remounted all grounds, have all power connections to pcm full...

Would this be pin 6 and 14 on the obd plug? Should mention I ordered the 30-0300

Heat soak, changing fuel rail pressure, amount of fuel in the port that is liquid vs vaporized. It is a useful metric. Yes stuff is mislabeled and...

I don't think your 4X4L table is stock. I looked at 2017, 2018 and 2019 stock files and they all look like this. 6th gear is locked out of 4-low.

First you cant mix 06-07 classic ETC hardware/calibrations with 03-05 ETC hardware/calibrations.

Sorry I missed this earlier... I never use the special functions to put the vehicle in open loop or disable fuel trims when I'm logging, I'm not...

have any of you guys seen a ve that looks like mine, really this things is god awful. smh.:doh:

https://m.youtube.com/watch?v=eOd_IudUkgM This guy has a few videos on how to do it. I?ve done it on my car. It?s not that hard if you follow the...

Would this be pin 6 and 14 on the obd plug?

sorry fellows just been really busy, ill post one tomorrow. i just want to thank you guys alot.

Why is Stoich 28.

Hey edcmat, I did a compression test before I even started checking anything else. I had 180 psi on all the cylinders. I also did a leak down test....

Hi Cringer - How did you come to determine this was engine off time? I don't understand how that would be a useful metric for tuning, given so many...

Okay will do thanks

It does run ok, a bit rougher than when its at 14.17 though. Ill finish getting MAF and VE dialed in and then revert to stock o2's and see if it...

Yep that?s what mine looks like, but my 1->2 isn?t 300 like yours, it starts at 340 and goes to 1000, but I think your onto it, I will set both 1->2...

Good news. Gentleman came up from his "Super Secret Speed Shop" and did some (okay, A LOT) of work on the PCM. After about an hours...

The connectors are black and I will test for continuity at the pcm connector to make sure that they are the front sensors.

It's probably the same if your table looks like this...change the 2-3 to 300.

2013

What year is your truck ? This looks different then my file

I just looked at my stock trans file and the 4x4L shift table has 1-2 shift set as -5 down the whole table. Maybe do the same for the 2-3 shift...

yes very true, if it was just a shit tune it would upset me but ehh it happens, everybody has an off day , but what really pissed me off is when he...