Page 1 of 1246 1234511511015011001 ... LastLast
Threads 1 to 20 of 24908

Forum: GM V8 Tuning - Engine, Gas (Gen 3)

(1997-2009, LS1, LS6, ...)

  1. Sticky Thread Sticky: If you want us to help with a tune or scan issue post your .hpt file, log & .cfg too.

    Started by jimmyblue, 10-19-2009
    92 Attachment(s)
    • Replies: 0
    • Views: 109,416
    jimmyblue
    10-19-2009 Go to last post

  2. Sticky Thread Sticky: READ ME!!! General tuning info and how-to's

    Started by WS6FirebirdTA00, 02-07-2006
    • Replies: 0
    • Views: 294,069
    WS6FirebirdTA00
    02-07-2006 Go to last post

  1. O2 Fulcrums what EXACTLY is airflow mode?

    Started by weinerschizel, 2 Days Ago
    • Replies: 3
    • Views: 128
    weinerschizel
    11 Minutes Ago Go to last post

  2. Idle Air changes after Key Cycle

    Started by Proxses, 1 Hour Ago
    2 Attachment(s)
    • Replies: 0
    • Views: 15
    Proxses
    1 Hour Ago Go to last post

  3. VE table before and after. What am i doing wrong ?

    Started by Aaronwelling1, 21 Hours Ago
    2 Attachment(s)
    • Replies: 6
    • Views: 117
    Aaronwelling1
    1 Hour Ago Go to last post

  4. HELP!!! Gen III Deka 80 Turbo $40k boat anchor

    Started by Jason.Henley, 04-20-2024
    2 Pages •
    1 2
    2 Attachment(s)
    • Replies: 20
    • Views: 592
    gtstorey
    2 Hours Ago Go to last post

  5. silverado 4l60e to th400 swap, wont rev past 3,000 rpm

    Started by dreyerw, 6 Hours Ago
    3 Attachment(s)
    • Replies: 6
    • Views: 110
    edcmat-l1
    2 Hours Ago Go to last post

  6. Why is idle timing so much lower than 4 tables?

    Started by borrone821, 4 Days Ago
    8 Attachment(s)
    • Replies: 18
    • Views: 416
    borrone821
    3 Hours Ago Go to last post

  7. 2000 Camaro LS1 - Manual Swap Help

    Started by rodizzle, 17 Hours Ago
    1 Attachment(s)
    • Replies: 6
    • Views: 143
    edcmat-l1
    5 Hours Ago Go to last post

  8. 02 5.3 turbo rich idle

    Started by silverustoturbo, 2 Weeks Ago
    2 Pages •
    1 2
    13 Attachment(s)
    • Replies: 21
    • Views: 723
    Alvin
    7 Hours Ago Go to last post

  9. P59 injectors scaling???

    Started by promobass, 5 Days Ago
    2 Attachment(s)
    • Replies: 13
    • Views: 337
    Alvin
    7 Hours Ago Go to last post

  10. P59 base running airflow problems

    Started by codykeen0923, 16 Hours Ago
    • Replies: 3
    • Views: 122
    edcmat-l1
    8 Hours Ago Go to last post

  11. Need help with first start

    Started by LeadFootedRacer, 1 Week Ago
    3 Pages •
    1 2 3
    18 Attachment(s)
    • Replies: 45
    • Views: 1,095
    LeadFootedRacer
    9 Hours Ago Go to last post

  12. Question Injector Data Repository

    Started by TheMechanic, 03-29-2022
    5 Pages •
    1 2 3 ... 5
    45 Attachment(s)
    • Replies: 94
    • Views: 16,664
    blindsquirrel
    21 Hours Ago Go to last post

  13. Idle and initial drive tune support needed

    Started by SilverS2kV8, 1 Week Ago
    1 Attachment(s)
    • Replies: 10
    • Views: 446
    SilverS2kV8
    22 Hours Ago Go to last post

  14. Gen 3, Deka 80 inj. 73 mm turbo

    Started by Jason.Henley, 2 Weeks Ago
    2 Attachment(s)
    • Replies: 11
    • Views: 340
    Jason.Henley
    23 Hours Ago Go to last post

  15. Startup Air/Idle Source

    Started by msassman, 3 Days Ago
    2 Attachment(s)
    • Replies: 1
    • Views: 95
    TheMechanic
    23 Hours Ago Go to last post

  16. New build fires but won?t run (video inside)

    Started by guhman2002, 1 Day Ago
    • Replies: 6
    • Views: 138
    guhman2002
    1 Day Ago Go to last post

  17. Erroneous accelerator pedal position percent?

    Started by abc, 1 Day Ago
    1 Attachment(s)
    • Replies: 0
    • Views: 72
    abc
    1 Day Ago Go to last post

  18. Knock Sensor Low Voltage Codes After Installing Turbo?

    Started by lineartuna, 1 Day Ago
    • Replies: 0
    • Views: 63
    lineartuna
    1 Day Ago Go to last post

  19. Base C5 tune needed

    Started by tylervalo, 4 Days Ago
    3 Attachment(s)
    • Replies: 14
    • Views: 392
    tylervalo
    1 Day Ago Go to last post

  20. PCM swap

    Started by Mood1977, 2 Days Ago
    • Replies: 1
    • Views: 681
    TheMechanic
    2 Days Ago Go to last post
Page 1 of 1246 1234511511015011001 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.