Are you removing the rear to 1 or the fronts to 1 O2Sensor
Type: Posts; User: mstang_man
Are you removing the rear to 1 or the fronts to 1 O2Sensor
I dont have any other files to compare to, some i am unsure of what i am missing.
Yes, the throttle valve is disconnected. what i have applied i still receive to dtc P2456-00 & U059E. I would assume the file i applied would have turned that off. everything is as far as fuel and...
So,
when you apply an xdf file to a tune file are we writing the entire or just the calibration? Just trying to make sure all the work doesnt get screwed up!!!
SO what i am seeing is a boost issue, during acceleration i can get up to about 50mph, and boost does not a get above 10psi. I am not sure what i am missing.
it seems ford has some built in logic that cuts power around 50mph with egr removed. no other changes to calibration other than egr turned off. only code that comes up p2425. with diverter valve...
Looking for information on EGR cooler delete on my 6.7L. We are in the process of making a 6.7 into a chaser truck. We do not have emission testing in my state. I been trying to learn how to build my...
its the Electronic parking brake symbol
Good Reading it more focused on 18-19 but info still applies. I assume turning off p0420, p0430, p0443, p0452,p0453 would prevent light on the dash. We dont have to worry about this in US as you...
Yeah thats looks about right from procharger..
Post your Pharmacy ads somewhere else. My dutch is a little rusty (translated)
buy orlistat 120 mg buy orlistat cheap online buy orlistat Austria
cytotec prescription-free misoprostol...
BORDERLINE KNOCK FOR 93 oct 03-04 Blown Mach 1, safe starting point
-5 -5 -2 4 7 8 10 11 12 13 14
-5 -4 1 7 10 11 13 14 15 16 17
-2 -1 4 10 13 12.5 14.5 15.5 16.5 17.5 18.5...
is your buddies car tunes with HP already or was it tuned with SCT ?
Did you change the Manifold Volume to 12.55
Disabling all these mapped points 1,2,3,4,5,6,7,8,9,10,11,12,13,15,19,23
Correct (0) Disable / Enable (1)
15-16 SCT Value i use on the Mustang. I use MAP Point 15 for the following
Mapped points to Emission reduction Distance set all to (15)
Mapped Points to Fuel Economy Distance set all to (15)...
generally on the older mustang 99-04 setting the base tune you would copy MBT and Paste into BNK, after getting the AFR correct dial spark from there. you may get 16-18*for SC and 18-21* on an NA...
Dont know if this will confuse you, but here is the tech definition. Hopefully i didnt miss anything..
starting around 2002, the MAXIMUM_ALLOWED_SPARK_TABLE disappears and is no longer used. This...
SO doing a little research and apparently there is has been an ongoing issue with the Forscan software and PSCM (Power Steering Control Module) and SASM (Steering Angle Sensor Module). According to...
The following spark source decode: In Livelink datalogg Borderline Spark, Max Allowed Spark, MBT Spark and Spark Source
in theory The max allowed/mbt table is used to clip the maximum spark that...
Yup, if the table your referencing in HP is "Pre-ignition limit". Besides Borderline knock, borderline tip in modifier, borderline tip in event, there is pre ignition for afr under piston protection....
short answer due to Torque Control
your looking for spark per-ignition limit Vs RPM Vs Load, which should be whats below
in SCT >SPARK> Under Idle> Max Spark Advance
Whats the Calibration? All the Files aren't all standardized like HP