113488
Type: Posts; User: Japeatr
113488
ok so a few things here that i need help with as I am trying to learn this better:
1. Base fueling: what table to help correct fuel? I went for a pretty extended drive and ran errands leaving the...
made the recommended changes and seems to be doing a bit better
tell me what you think? i still have 1-2 deg of knock that i need to pull out as well
ill give it a shot! really appreaciate your help btw!
managed to get a full pull but boost seems to want to settle down around 12-15psi depending on load
Upped the temperature limits in the higher load cells above 4k rpm by ~75F, and the surrounding cells in ~3k by 15-25F. Going to start here and see how it runs.
Also put in a 160F tstat as my fans...
Disregard last question, I just needed to read and determine rate of change
Ahah! You the man! Is this for cats or manifold protection? I guess what im asking is how high to raise it?
Let me know what you think? Seems like truck isnt pushing more than 12-15psi, but is holding it better!
I cant seem to find Torque airflow limit and torque max protection source?! What am I missing?
ok still appears to have an issue, any thoughts?
log attached
Didn?t get a chance to log it but it is so much better. Truck pulls super hard, just need to verify the computer is reading 20psi and fix the 1-2 and 3-4 shift under wot and im set!
Big thanks...
Much better, I didn?t get a chance yet to grab a log or a full WOT pull but can already feel less hesitation than before
Ill grab a log later today
thanks let me give it a shot!
Thanks ill try! Do you have some histograms or configs that would help?
logs attached - log 2 you can see if at 3:59-4
ditch VE and jump to MAF, then just scale your injectors
I am trying to hunt down an issue with my truck dropping boost. it will spike to about 20psi then pull boost back to ~10 no matter the settings.
i have checked the BOV and IC clamps. but wondering...
Im trying to understand the MIL code settings (0,1,2,3...)
Im looking to turn off P013A/C after high flow catalyst installation
Thanks
:{
wish I could figure out my config histos into the new graph formats
the vehicle is no longer in the shop. I can send tune file tho
scanner would poll supported parameters, my config didnt seem to capture any histogram data, the graphs were plotting, but the it wouldn't do anything when asked to read dtcs
I was trying to read codes on a '08 Cobalt SS (LNF). it would grey out when button was pressed in scanner but then would not display any codes, just blank fields. MIL was on.
my '13 does not have that table
on my 13' im not finding the pedal ratio tables for each mode, can you elaborate?