A P01 pcm can run an L31, google black box to ls1 pcm swap
Type: Posts; User: orange ss
A P01 pcm can run an L31, google black box to ls1 pcm swap
Swap an LS1 24x crank into a Vortec 350? No, thats not how that works
No, i thought it odd HPtuners provides an option to exceed the threshold but it doesn't work
Trying to adjust IAT cal data in a Gen 3 411 pcm for a Rife sensor. I get a message concerning exceeding limits and a prompt to allow excedence. I click yes but the values stay the same (284 for the...
Have a Gen 3 411 pcm and Rife sensor. Tried adjusting the cal for IAT but get message saying numbers exceed the max value. I also get a prompt asking if I want to override the max value. I click...
I log both using the inputs on my MPVI Pro, just split the w/b analog circuit and configure the inputs appropriately.
PCM provides ground circuit
I think I still have the 96 conversion info
segment swap, yes..but I would use the F-Body
should add, that info is for P01 computer, not sure about P59
add a microswitch to the shift lever, select P/N Switch under Trans tab.
maybe trans related? ZL1 auto?
power output control? vehicle dynamic delta?
2 ecms, 2 separate issues apparently...i couldn't connect to my buddy's spare ecm for some reason. The original issue was resolved with pin reposition.
ECM, I assumed those pins were hard mounted to a board, apparently not
recessed pin (C2,19) in the PCM not making contact with connector, explains why I couldn't communicate in the vehicle or on the bench. I pulled the pin back out with needle nose pliers, everything...
MPVI1, I did contact support, first response was electrical interference (noise), suggested using bench harness ( already tried that), second response was to download beta version...I tuned a Gen III...
received error message trying to connect to vehicle with LS1 swap. Harness is new aftermarket, all circuits valid/operational. Tried 2 different pcm's in vehicle and on bench harness with same...
I believe there is an option for PRNDL ( trans section?), None or P/N switch for that PCM...use a micro switch to switch ground ( I believe P is ground)
need to do a system segment swap to utilize the a/c pressure transducer function
plenty of 5vdc circuits from the pcm...TPS, EGR, A/C, etc and even some that are not used..tap into one of them
good find, thanks for following up
pin 58 is serial data, looks like wiring is correct
same issue with Windows 10
no ticket, some parameters not recording during stand alone data logging....problem is well known, recommended fix was to use the Beta version until the problem got resolved.