Search:

hello all,
i have recently purchased a 2015 Volvo XC60 T6 polestar.
i was wondering what software people are using to tune or gain access to the pcm of these?
i believe it is a denso operating...

hello all,
would any one have a stock 2.8 liter diesel Toyota Hilux file?
thank you

what vehicle/operating system?

yes 2018 3.2 auto

hi all,
i have a quick question in regards to tuning 2018 3.2 ford ranger.
i am a bit cautious after seeing "brickable" in the flash window, is this writing an entire file or just a section/patch...

non dpf use 208 as far as i am aware.
i am using innovate LM2 wideband with there own sniffer pipe unit, still only using an LSU 4.2 sensor.
the LM2 can be calibrated for diesel, as i am sure the...

PX2 with SID 208, so being manual also of this era it has no DPF.
raising the torque limits i think improved the economy drastically.
Drilling hole into dump pipe and putting pyro in the hole,...

awesome thanks for the feedback.
i am going to spend the day with the vehicle this coming saturday.
i will post some logs and the final tune with feedback.

Great thanks heaps for the reply and direction.
i am going to be back at this vehicle in the next week or so. i will defiantly post up before, progress and after logs and files.

Hello all,
i am by all means not looking for a free ride here but more looking for someone with experience tuning diesels.
i have tuned hundreds of LS and Ford stuff but never really touched much...

South Gippsland, Victoria, Australia.

as heading says, here is a stock read from a 2019 Toyota Landcruiser 1VD with transmission.

Hi all,
as the thread title says i am seeking if anyone has had experience with these SID208 in the ford ranger with the 3.2lt.
is there anything that i should be doing during reading/writing?
i...

delete all your channels and repoll the channels.
this will fix it. its a pain but is all i could get to work.

re-flash with a dealership tool back to stock and start over. mdi should work.

i used a heavy duty "Mcdodo" cable.
this cable also has its own power/connection indicator.

all fixed with update

Good evening.
i am having an issue since my last update today.
i went to read my own personal vehicle after install and resync of my mpvi2 as i do to check operation and all good. i then went to...

delete all your channels and repoll

Got a file to share? Just to be sure :o

same issue, unable to clear. only after read.

100% agree, plus usb cables.

best way is to adjust the wideband through your LM programmer accordingly.

Im not 100% sure how it works as mine was already setup, but have you tried to re-sync the device?

Got the reply Bill thanks, it has been working fine since i have re-done all my channels.
i will keep the fix they sent me just in case it plays up again.