Can anybody provide stock file for 3.2L V6 and ZF9 please ?
Type: Posts; User: Stez
Can anybody provide stock file for 3.2L V6 and ZF9 please ?
Thanks Jim
Jim, can you make a file for remote flash with Delete Emissions and AdBlue ?
Is there any chance to turn off Ad Blue in the calibration of cm2450B ?
any input on this platform?
Thank you so much for reply!! i will try it!
in the Torque Inverse tables etc...? i noticed stock tables highest load is 2.4 so that could limit my max desired load?
Please advise or link to - how to raise Desired Load over 2.4 ... i maxed all load limits, and raise significatnly Torque DD tables, TIP desired upped as well... etc.. but cant make anything so...
Please advise, for Dodge Hemi engines 6.4/6.2 (GPEC2A PCM) to which PCM pin need to connect Ethanol sensor signal wire so ECU could use it for Flex Fuel blend?
Thank you so much Tyler, i'll try!
any hepl ?
101355101356
please see log file and tune files attached
Please advise, which table responsible for Desired TQ limit? what ever im trying to put into Driver Demand - i cant see higher number of about 564 Lb Ft - i assume some table limits this number, but...
Was this issue fixed? i have LT1 engine swapped w/ E92 ecu... and it dont want to start.... VATs and Starter diag both Disabled , anything else need to be done with it?
i did tried to change to Calibration and GMLAN... that doesnt helped (( will try to put 217mph number... i hope it will help somehow, but i guess i tried that as well... could be the problem...
It limits speed via spark cut
https://i.gyazo.com/bc20296baeb1454f2a3aebe48740d0cd.png
Please see this
Yes, its E92 ecu, i tried everything in the Speedo page to raise all limits up to 317mph, as well as put Condition: Enable RMP up to 7000rpm so it never worked at all, but it still Limits the car on...
We have Corvette C7 LT1 + Procharger SC kit installed, the car run just fime, untill about 300km/h, and then it hits the limiter, i tryed everything in the ECU software to turn it off, but it feels...
Does datalogging work for JTEC STR10 ? i was able to read and open ecu rom, but not able to datalog anything at all with mpvi2 cable ...
does Ngauge will work for JTEC - RAM SRT10 2004?
I tuned Q50 via HPT, all seems to work ok, except - Engine Diagnostic is not active - there is nothing in there, the same thing for Speedo , why?
Please see the log file, im trying to get more power of the car, but it closes the TB , i'd assume because of Desired BT is too low, i've tryed to raise Demand Tq and Torques Calc model in that area...
The car is Mustang 2013" with Edelbrock SC attached, it runs just fine under heavy loads, but have very strange issue with very light loads, sometimes if i press the pedal very slow up to 15-20% , TB...
Please help, we installed Supercharger kit on Mustang 3.7L 2012" , calibrated engine data - it works good on one gear , + 100hp added.
When cruising on the street everything wokr good untill Full...