I have a customer who wants a tune on his 2024 Maverick and was curious if it has been added yet, the list shows 22-23. I have tuned a couple 22 models.
Thanks,
Randy
Type: Posts; User: Volstang
I have a customer who wants a tune on his 2024 Maverick and was curious if it has been added yet, the list shows 22-23. I have tuned a couple 22 models.
Thanks,
Randy
you need to update tune for the gear change
Had similar issue with the KB 168. Turns out the TB is a POS. Had several bad ones before getting a good one. It would be less painful if someone ran a rope through it and beat the sh*t out of you...
Here you go
here you go
It would be best to lock the IMRCs when going with boost, they can get blown closed. Set WOT Lambda to 0.79-0.78 and run 15-17* of timing. You also need to rescale your Mapped Points.
Here you go
I've tuned the ESS and other supercharger setups. Send me your file along with supporting mod info and I'll send you a base file to start with. PM me.
This should get you in the ballpark.
post up your tune and I'll make changes
What engineermike said is 100% accurate.
Thanks Mike
Hey Engineermike, you mind sharing your channel config for Gen2/3? Always good to see what others are logging.
Hey Wes,
You still disable DTC 0605 on the 2018+ Mustangs. Make sure you log all your sources and also know your car has twice as many Mapped Points as your previous car and OP is not used on this...
125431
File attached. Like Bill mentioned above, you do NOT want to do a Flex Fuel tune.
macAtak79, is this tune updated for the NX2 speed density info?
TC-298 or 298B
its possible its not a stock file. could be an aftermarket tune file
This one is Stage 2.
Thank you so much for sharing this!
Post up your tune Fahad. You can start by going to Fuel-Cutoff/DFCO tab and in DFCO section raise Enable RPM to 7000rpm and Disable Load to 0. Then go to Spark-Advance tab and in MBT 0-3 take the top...
Thanks in advance.
Completed the MAF tuning, car is running great. Thanks for input
Nothing was way off. I did make some minor MAF adjustments but the clip I was hitting was In Eng Diag tab under Airflow, there was a Max Load table I needed to bump up the max load a bit in upper...
P1X large pulley (7-8psi)
DW 95lb injectors
DW400 pump
Long tube headers