Did you pull out the fuel pump relay
Type: Posts; User: sayangetsome
Did you pull out the fuel pump relay
Think you can help me out? I got the stock tune posted
Would you mind posting you current to tune with the injector pulsewidth setting need to adjust mine too
Have 5.9L with 125 Injectors. Need help calibrating them in into the truck. Everything else is pretty much stock. I know you mess with the injector pulsewidth tables and some of the diesel timing but...
I have a 5.7 2008 tundra. I added the supercharger kit and injectors
can someone help me calibrate the injectors in or give me the steps
also with the maf plugged in it runs horrible but withe...
4807415254
4807415254 call me someone lol
I got it to chop messing with mapped points a bit and intake and exhaust cam angles but it just bounced back down really low in idle and would bounce a little in that area up and down
Can someone give the ghost tune or help me with getting some chops out this truck? I will post stock tune here. I can get it to chop it a bit but idle surges down really low and adds alot of timing...
I looked on the supported vehicles list and seen that year isnt on there? Is this true?
I adjusted only FA stoich and it give us a worse idle. My LTFT say -33%. I subtracted 33 percent from fuel mass tables and it doesnt make a change. Then I reset the adaptives and it wont even start....
Hey guys have 2011 5.7 charger with 650cc injectors. We are running e85 fueling. Need help with injector data calibrating on injectors. LTFT are running rich from what I can see in the log file. From...
can you post turbo tune? I just installed twins
Run it open loop and set your EQ to 1 across the board
my fix was gear ratio and tire size
Post your tune
Lmk i need this fix too
BTR Stage 4 Cam
68mm Turbo
NO MAF
1200cc Injectors
HO alternator
Can someone help me get this thing to idle....
Have a stock tune only took out 5 degrees timing, adjust injector flow rate,...
Trying to read tcm off 05 durango 5.7 hemi
when trying to read it fails
i select all dodge controllers and they all fail
i tried ngc4(fail) esgs52 and esg53(fail)
I dont think has support for the speed limiter yet on Nissan
Needs this answer also hopefully you can get help
I have a 2005 NISSAN TITAN.
Im trying to read the stock file from the ECM.
When trying to read it asks for the VIN.
I type in the the vin and it just says READ COMPLETED.
It doesnt show...
Adjust your MAF table bump up fuel on top end
your fuel trims look really rich try dialing in your MAF and VVE tables a bit more that should help in general.
All the torque restrictions in the trans are still enabled on the torque managemnt...
GoT ITTTTTT!!!!! im dumb..... VE table was the issue, i was way too lean