Search:

Type: Posts; User: Higgs Boson

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    5
    Views
    106

    post a pic of your VVE table

    post a pic of your VVE table
  2. Replies
    6
    Views
    221

    been running full time open loop for years,...

    been running full time open loop for years, honestly.
  3. https://forum.hptuners.com/showthread.php?80784-To...

    https://forum.hptuners.com/showthread.php?80784-Torque-Request-Rate-Limits
  4. Replies
    11
    Views
    450

    what are your cam specs, I would be surprised if...

    what are your cam specs, I would be surprised if it's "too much" rather than just a tuning issue.
  5. Replies
    8
    Views
    709

    A lot of sluggish power issues are in the spark...

    A lot of sluggish power issues are in the spark tables. Having 5 degrees of spark off idle isn't ideal. Raise it. Just watch for knock in high gear low RPM tip in. Don't raise it there.
  6. Replies
    71
    Views
    7,921

    out of all the tables, one drop down box for...

    out of all the tables, one drop down box for Enable or Disable is for Vehicle Stationary. All the rest are not.
  7. Replies
    7
    Views
    1,247

    set the whole table to 280 and log some data

    set the whole table to 280 and log some data
  8. are you considering vvt retard in your...

    are you considering vvt retard in your calculations?
  9. Replies
    48
    Views
    2,398

    Maybe I disabled something you didn't? If you...

    Maybe I disabled something you didn't? If you want to send me your tune I will compare them.
  10. Replies
    16
    Views
    845

    If you have to lower your MAF or edit your PE...

    If you have to lower your MAF or edit your PE table in order to keep from running out of fuel pressure or injector PW then you will go lean, if you compensate for that by spraying meth then you are...
  11. Replies
    48
    Views
    2,398

    The VVE is not referenced for fueling if you are...

    The VVE is not referenced for fueling if you are MAF only. Torque calculations do reference the VVE, however.

    I have a 1000rwhp E85 whipple Z06 right now with perfect driveability and no torque...
  12. Replies
    55
    Views
    13,847

    They should no be zero'd out.

    They should no be zero'd out.
  13. Replies
    16
    Views
    845

    If you are not getting commanded fueling then you...

    If you are not getting commanded fueling then you need to adjust your MAF as long as your fuel pressure isn't dropping and/or your injector pulse width isn't going past about 6ms.
  14. Replies
    16
    Views
    845

    Gas 14.7 / 1.22 = 12.05 afr E85 9.85 / 1.16...

    Gas
    14.7 / 1.22 = 12.05 afr

    E85
    9.85 / 1.16 = 8.49 afr

    12.05 / 8.49 = 1.42

    1.0 / 1.42 = .70
  15. I disable Clutch Fuel Cutoff on my tunes, maybe...

    I disable Clutch Fuel Cutoff on my tunes, maybe you should look at airflow instead, like is the throttle closing properly when you release the pedal.
  16. what are your modifications

    what are your modifications
  17. Replies
    48
    Views
    2,398

    this probably sounds funny, but I run all my...

    this probably sounds funny, but I run all my personal cars full time open loop and ditch the factory narrowbands. I have three widebands in my Z06, lol.

    Once tuned, none of my cars deviate more...
  18. Replies
    4
    Views
    343

    https://forum.hptuners.com/showthread.php?75815-T8...

    https://forum.hptuners.com/showthread.php?75815-T87A-controller-versus-T87
  19. Replies
    2
    Views
    222

    in maf, need breakout

    in maf, need breakout
  20. Replies
    7
    Views
    729

    I usually just copy the Low Baro table over to...

    I usually just copy the Low Baro table over to Medium and High
  21. Replies
    22
    Views
    1,366

    correct, just pointing out that I don't recommend...

    correct, just pointing out that I don't recommend one with an LT4 pump, including on an LT1 with the pump swapped over.

    lots of people upgrade to LT4 pumps and cams.
  22. Replies
    22
    Views
    1,366

    The LT4 pump is a stroked LT1 pump.

    The LT4 pump is a stroked LT1 pump.
  23. Replies
    22
    Views
    1,366

    I don't run a lash cap ever and have no problems....

    I don't run a lash cap ever and have no problems. Every time I tried using a lash cap (in 2014) I had issues with it.

    Currently a BTR Stage II Blower Cam with 38% lobe in an LT4 with no lash cap,...
  24. I tried that one in 2014 and it didn't do...

    I tried that one in 2014 and it didn't do anything.
  25. Replies
    4
    Views
    368

    yes, forscan works

    yes, forscan works
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4