Either the vehicle isn't read properly in VCM Scanner and doesn't display any PID's except my WB, or when the vehicle is recognized properly the WB channel disappears.
It also glitched out completely and caused a loss of communication with the instrument cluster and set a permanent code (all gauges go flat). After this happened the connection to the car only lasts a split second before freezing in VCM Scanner.
I was testing it on my daily, a 2013 Honda Accord Sport. I'm about to head outside and test it on another vehicle in my driveway to see if it does something similar.
I just tested it on my 2013 Mini Cooper S, and I had I also could not get the AEM to show up on the channels list. No CEL issue, and no connectivity issue with this car.
I'm guessing the CAN pass-through is only for supported vehicles?
It should show up as "WB EQ Ration 1 (SAE)"
It does not show up in the "X-Series UEGO ( 30-0300 )" section. That is for widebands that are connected via the ProLink.