pro link + no get data from gauge !!

[mr.joker]

i have problem from 2 week ago and i do so many search to can know what is problem but i didn't know it

WB ( AEM 30-0334 ) keep read in scanner 8.2 - 9.0 AFR so fast like its hanging between these numbers

in gauge read normal 14.7 - 15.3 AFR ... but in scanner no get this data .. i change pro link+ already and i got new one .. i get same problem

it could be a electric problem ?? idk

anyone can help .. plz ?

[TheMechanic]

https://youtu.be/ozJz-pNFCuo

For those using AEM 30-0334 with HPT, when adding channels and searching using "WB", HPT provides channels for 03-03xx WBs, not channels for 03-0334 OBd2 WB's. YOu have to follow channel hierarchy as shown below..

One thing that confuses a lot of people is the channel naming convention.

In the add channels window, there is a section:

Code:
External Inputs
|_AEM
|_X-series UEGO (30-03xx)
|_ WB EQ Ratio 1
WB EQ Ratio 2
etc. Which LOOKS like it should be the exact right stuff. BUT, IT IS NOT! That is for the AEM 30-0300/0310, when connected via the ProLink.

The correct channels to add are in this section:
Code:
Engine
|_Fuel
|_Open & Closed Loop
|_Oxygen Sensors
|_ 12 WB EQ Ratio 1 (SAE)
12 WB EQ Ratio 2 (SAE)
12 WB EQ Ratio 3 (SAE)
12 WB EQ Ratio 4 (SAE)
etc. which one will depend on which PID value you selected in the 30-0334 setup UI ( On the gauge )

[mr.joker]

i use pro link+

so i open

external inputs
mpvi2+
pro link +
mpvi2 PL A/D input 1 ( red )

this what i was use .. then it would not work anymore

before i use transform i see volts 0.35v - 0.60 v .. is that normal or no ??