6.4 timing question

[h300033]

Are there additional timing modifier tables not defined in HPT?

On a WOT pull it?s calling for -20 degrees of timing but all the timing tables show -10 in that area it should be operating in.

[PSM 6.4]

Yes, multiple

[h300033]

Are they accessible via UDP?

I appreciate any help you can give me.

[donnies_diesel]

1, you are not looking at the correct tables, 2 the multiplyer for timing in incorect in hpt for a 6.4, the vcm scanner shows the correct timing value

[JaegerWrenching]

In your case, you are observing that during a Wide Open Throttle (WOT) pull, the engine is requesting -20 degrees of timing, but the timing tables are showing -10 degrees in that operational range. This discrepancy could be due to various factors, including custom tuning requirements, specific engine characteristics, or performance optimization strategies.

Regarding the question about whether there are additional timing modifier tables not defined in HPT, this can vary depending on the specific tuning software and the tuning strategy being employed. Different tuning software packages may have varying levels of granularity and customization options when it comes to timing modifiers.

You literally asked chat GPT for the answer and then posted it lol.

[JtRenegade]

You literally asked chat GPT for the answer and then posted it lol.

I was just thinking that haha

That's a lot of words to say absolutely nothing

[h300033]

Is there a way to access these timing modifier tables?

[h300033]

I will pay $$$ to anyone that can help me out with this.