Logging AFR through a P3 Gauge

[[email protected]]

New to all this and recently got a 2016 ATS-V that I'm doing a little work on to bump up the power and I have a bunch of questions. But I guess I'll start with the wideband install.

I'm installing a P3 gauge in my car and was looking at installing the AEM X-SERIES INLINE WIDEBAND
Bosch LSU4.9 part # 30-0310. I was going to wire the analog output from the wideband to the P3 gauge. My question is can I read the AFR data through the OBD connection on the P3 gauge in HP Tuners?

Thanks, Tony

[readytoboost]

From my understanding, the easiest way to do this is using the Prolink+ cable. If you have an MPVI3 then you just need to buy the cable. If you have an MPVI2+ then you need to purchase the Pro Feature Set to use the Prolink+ cable.

I believe you can just do a 3 way connection between the P3, AEM, and Prolink+ analog wires. This should allow both the P3 gauge and HP tuners device to read the data from the wideband sensor.

The Prolink+ cable then plugs into the back of the MPVI device. Additionally, be sure to add the logging channel to your VCM Suite after all is completed. Instructions for adding Prolink analog channels here.