I did a entire read on my stock 99 vette today. Everything went fine with that. I then went in the house and starting changing some stuff. I then went out to load it into the car. I did not do a write entire, I did the write calibration only. It was all going good till it stopped and said timed out. I have no aftermarket stuff in the car as stereo tv etc…. (so It shouldn’t be wiring issues like I’ve read on other peoples.)
I then waited a min or two and, hit the close button. When the computer said it timed out, the dash starting sending messages on the little screen, reduced power, fuel, service engine soon, etc…. I shut the key off and waited a min or two again and tried to start the car. All it did was turn over and not fire. It then started saying all the stuff on screen again..
After that I just let it be. What should I do next??? I think on the bottom of the editor screen I think I seen the vcm volts in the high 11’s… 11.9 or 11.8.
And what’s the infolog?? If you need that please let me know how to get that.
Thanks for the help!!