Results 1 to 2 of 2

Thread: Changing RPM limit and A4 shift delay

  1. 04-04-2005 #1
    maxeffect
    maxeffect is offline
    Potential Tuner
    Join Date
    Feb 2005
    Location
    SC
    Posts
    2

    Changing RPM limit and A4 shift delay

    After reading the PCM and opening the file with VCM Editor. I open Engine, General, Fuel Control, Fuel cutoff, then adjust under RPM Limits.
    P/N Cutoff RPM,
    P/N Resume RPM,
    Bad Vss Cutoff RPM,
    Bad Vss Resume RPM.

    Can I make these changes and save them directly to the PCM?

    I'm still working on the Upshift and downshift settings. Not sure how to adjust yet. Still reading the help file.

    Thanks
    Rich

    Reply With Quote Reply With Quote
  2. 04-04-2005 #2
    jimmyblue
    jimmyblue is offline
    Senior Tuner
    Join Date
    Nov 2002
    Location
    Central Florida
    Posts
    2,503

    Re: Changing RPM limit and A4 shift delay

    Those you mention are all for "abnormal conditions".
    You also (most importantly) want the Cutoff RPM vs
    Gear.

    Check out the spreadsheets thread in the V8 General
    section and some of my .bins on Horist's site for some
    ideas about part throttle shift tables. Bearing in mind
    the differences between setups, etc.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »