-
Tuner
lean first gear
was tuning a holden gen 3 ls1 with ETC, heads/cam setup.
I switched to SD mode since his MAF is not working. disabled ltft's and using wideband to tune partial fueling and WOT.
I have a problem where 1st is always lean... 2nd and 3rd gear is fine though.
I have posted a log which shows IDC/injector pulse width increasing but still shows 1st gear lean. I haven't logged the wideband through the scanner, but i do see it with the lm2 hooked up in the offroad pipe.
You can also tell by seeing the o2 sensor voltage in the scanner.
Any advise?
-
Tuner
-
Tuner
-
Tuner
your case is different.. in my case its the a/f ratio is 16's and immediately goes to 12's.