Results 1 to 2 of 2

Thread: problems reading PIDS

  1. 12-27-2012 #1
    Mike@ADS
    Mike@ADS is offline
    Tuner
    Join Date
    May 2006
    Location
    Bowling Green, KY
    Posts
    103

    problems reading PIDS

    I am trying to log a 2010 Escalade and cannot get quite a few PID's to pop up. I cannot see INJ B1/B2 or the MAP readings. I can't even get the LTFT B2 or STFT B2 to pop up. The readings in the chart are just blank. I know I can see these things on the Tech2 and Solus, just not in HP. Any hints to get these to pop up?

    I already deleted the .os for this vehicle and repolled it and that did not work.

    Thanks,
    Mike
    Reply With Quote Reply With Quote
  2. 12-27-2012 #2
    Mike@ADS
    Mike@ADS is offline
    Tuner
    Join Date
    May 2006
    Location
    Bowling Green, KY
    Posts
    103
    Nevermind, I figured it out. I did not have the parameters in the main table page, just a stupid mistake on my part.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »