Can I fool the speed signal to the ECM, without the TCM in place? I tired pining my V.S.S to the PCM were the manual E40 would go, and no speedo, no speed on the scanner, think it would work if we had the same speedo tools available to us that the E67 has, but we don't, which is frustrating.

Does the PCM revice its speed via high signal pin 45? From the TCM, what signal is this? Is it a 4000ppm signal? What if U used a Drac module to take my V.S.S and convert it to a 400ppm and wire it to pin 45, with no TCM in place would this work?