Tuning for Ford Racing 80lb 840cc Fuel Injectors

[ElecTech]

Can the values in a calibration axis be changed to match the axis values in Eric's table? Have the same number of rows, but header values are very different. My values range from 50-70psi whereas the tables here are from 20-60psi.

Click on the axis title. Make changes. Close both tables. Reopen table. Changes should be there.

[MMGT1]

Perfect, I know I can change the values in the tune but I didn't know if it would work on the receiving end.... thanks very much!

[8850]

Can the values in a calibration axis be changed to match the axis values in Eric's table? Have the same number of rows, but header values are very different. My values range from 50-70psi whereas the tables here are from 20-60psi.

Yes, they sure can be changed in your file.

[MMGT1]

Starting a new thread. I have questions about a couple of tables like this.