Boot Loader Download Request Timed Out

[michael101]

I'm unable to get past this step when scanning my ECM. Every attempt leads to 'Failed' during the 'Preparing VCM' step.

• Battery voltage at the OBDII is 12.56V during these attempts.
• I tried adding a 2amp charge with no success, so battery voltage was at 14.6 at that time.
• I am able to see vehicle stats using VCM Scanner (i.e. throttle position change, temp, etc.)

VCM Boot Loader.JPG


Operating System: Win32NT 6.1.7601.65536
Microsoft .NET: 4.0.30319.34209
CPU: Intel(R) Core(TM) i5-4310U CPU @ 2.00GHz
Available Memory: 13,501 MB

VCM Suite Product: VCM Editor 2.24.1170
VCM Suite Key: xxxxxxxxxxxxxxx
VCM Suite ID: 1271xxxxx

GM Credits: 2 used out of 8 purchased.
Ford Credits: 0 used out of 0 purchased.
Dodge Credits: 0 used out of 0 purchased.

License slots available: 407

Single Vehicles:
xxxxxxxxxxxxxxxx - GM Firebird/Camaro (V8) 2000

ID: xxxxxxxxxxxxx Date: 08/08/14
Hardware: 121 Firmware: 120
Part Number: 6220
Rom Status: 0 3F 0 81 0 1 0 0 FF
SPI Info: 40 15 FF FF 4E 41 0 0
Config: CC 88 0 0 0 C8 System Status: F7 0 0 0
Comm. Status: 0 0 0 0 0 On Time: 00:10:01.0650000, 00:09:56.3250000

Type: GM Firebird/Camaro (V8) 2000, P01
VIN: 2G1FP22G1Yxxxxxxxx
VCM ID: 1DG0677Q9044
ECM OS ID: 9381344 [Editor] [Scanner] P01
ECM Seed: 0

[MattH@HPTuners]

Email [email protected], be sure to attach your debug.dat.

-Matt

[michael101]

Problem resolved. I had interference from my Dakota Dash interface module, once unplugged I was able to communicate from my laptop to the vehicle ECM.