So what tables would I need to set up for a newer vehicle with Virtual VE tables utilizing MAP/BARO pressure ratio on y-axis and RPM on the x-axis? Here is my log and tables. Why do I richen tune when I use paste special - 1/2? Is there a different formula I should be using due to the MAP/BARO ratio table values that I am changing? My log is open loop with EVAP purge unplugged. When I upload a log, does it include the tables/graphs I have made or do I need to somehow upload them also? This is fairly new to me. Thanks for the help.
Last edited by DGS; 10-21-2018 at 07:36 PM.
Reason: additional info
You would set up a chart with rpm on y and use pressure ratio selection under math at the bottom of list for x. Then log your map, baro, and a/c pressure in your parameter list. Make sure the scales match the VE table. Once your logging, the data will log if all the settings match.
Thanks very much for your post, it was very informative. I've went through this in a/f ratio error and have had no problems. When I used the same process on EQ errror I get nothing in the tables. I used EQ Err under maths with no luck. I don't see user defined maths any more either. Does anyone have any ideas. I'm running the 2 bar OS system and cannot get data under power enrich without it. Thanks!!