Hi guys,
Have been digging around readying the ute for dyno time, but have one constant annoyance.
I Cannot work out why the throttle will open to commanded values with the engine off, but when it exceeds around 62 degrees with the motor running it throws up a CEL and 2 codes ( P2110 and U0100 )
I have worked through the tables to see if i can isolate anything, but so far, nix.
The only improvement over stock was achieved by copying the values from the R spec .hpt in the repository.
Any ideas?
Have spoken to a pro tuner and he had the same problem, but when the same values were input via an SCT box, the issue didnt replicate.