I've been making many attempts, changing random parameters, returning things back to stock, reading on the forums and making suggested changes. I can't keep my mapped point in OP during WOT pulls. It always goes to the mapped point with the closest cam angles, usually mapped point 8 (IVO -50, EVC 20) and mapped point 7 (IVO -30, EVC 20). I have disabled mapped points 7, 8, 9, 10 and 11 just to see if it would weigh out between the other tables, and it was in OP 100% of the pull. Then I did a dig and had all kinds of knock, I didn't want to give up the timing.
I have a log/file from today, some things are stock, some things are changed. .
I get torque control from spark source and throttle angle. I also lose throttle area when the the weight changes. These are not finished tunes, but any suggestions I'm up to try.

Log
stayinop5.hpl
File
stayinop5.hpt

older log
older_log.hpl