so recently I decided to try out the standalone datalogging while out tuning my 02 Camaro z28. I was able to load the config (took about a minute for it to load though?) from the vcm scanner into the hp tuner box and after I fired up the car and disconnected the connector that's between the box and my laptop and pressed/held the record button, the "ERR" indicator lit up as well as the "BUSY" light. when I pressed the "STOP" button, it did nothing. i unplugged the OBD2 connector and reconnected to retry but to no avail. I'm running version 3.2.125 fwiw. am i missing something or am i to email bill and open a ticket from there?