So after lots of searching I found enough info to get my lc-2 reading on hp tuners basically I hooked the yellow analog wire from the Lc-2 to my high pressure A/c sensor wire the orange and black wire. Here is a write up on the wiring. file:///C:/Users/Owner/Downloads/MPVI%20and%20MPVI2%20WIdeband%20options.pdf

And here is a video on how to set up the sensor to read on Hp tuners. I had to make some adjustments to my calculations to get it reading the same as the logworks gauge but it works.

Here is the numbers needed to do the user entered math:
Analog Output #1 (Yellow) is configured as 0 volt = 7.35 AFR and 5 volts = 22.39 AFR; Analog Output #2 (Brown) 1.1 volt = 14 AFR and .1 volt = 15 AFR.