Results 1 to 2 of 2

Thread: E38 ECM Requested and Delivered Torque Signals

  1. #1
    Potential Tuner
    Join Date
    Mar 2014
    Posts
    2

    E38 ECM Requested and Delivered Torque Signals

    I've been doing a lot of searching and can't seem to find an answer to my question so I'll see if anyone on here might know the answer.

    I have a 2005 Chevrolet Colorado (Previously a 2.8L with a P12 Controller) that now has an LS Swap harness with an E38 Controller in it. I was trying to get the factory Colorado ABS wired up and I'm trying to see if the E38 has compatible outputs for the stock ABS unit.

    According to the factory diagrams there are two signal wires coming from the P12 controller for Requested and Delivered Torque along with the VSS Signal. I'm exactly sure what the signal is that it's outputting. I haven't been able to find an E38 Pinout that has these outputs in it. Not sure if that controller doesn't use them or if they might be using a labeled as a something else.

    If anyone has any info on this it would be very helpful.

    Here is the Factory Colorado ABS Wiring Diagram:


  2. #2
    Potential Tuner
    Join Date
    Mar 2014
    Posts
    2
    Anyone?