I travel a lot and and only get a little time to do yard work honey do lists and car work. One thing I have noticed is that my O2 sensors are sluggish. The trims are good +/- 2%-5%. I know one of the reasons is because the sensors sit further back since I have longtubes. I also read somewhere, I think it was Higgs is that you could set your milliamp voltage slightly different to help, but looking at the tables in Engine>Oxygen sensors> Integral delay there is also an amount of time to declare a rich/lean switch condition. Is it feasable to shorten the period? The logic would seem that you can adjust the voltage to declare how much mV, and then how much time it would require to se it before switching?
Or would this cause other problems?