What have you all been using for values? I have a G8 that acts really wierd. First banged my head on wall with a POS TPIS 102mm where the blade was crooked as hell and didnt seal worth a damn. Stuck a 103mm NW on it and certainly seals better but scalar values are non sense. I can use a stock scalar (4700-5100) or typical NW 102mm value of 7280 or max it out at 8190 and idle airflow values are not doing much different, read way out of wack (3 lb/min Desired Idle Air or something like that when it should be 1.3-1.4ish). Just put a scalar of 3000 (wayyyy smaller than stock) and it all seems to act normal with Idle Airflow Values falling in line??? It throws a P0606 ECM/PCM code now occasionally though