-
Tuner in Training
Needing help to get aem 30-0334 to showup in pid list
I can't find it in the channels list anymore. I haven't use the gauge in awhile to tune with.
-
Try this. When connected and with the wideband running from the scanner menu, select repoll parameters.
-
Tuner
Did you configure it in the add-on I/O's? There's already a Configuration for AEM in the list you just have to select it.
-
Advanced Tuner
1st thing is to make sure that you actually have a proper 30-0334. A while back there was a batch of 30-0334s that were shipped out with 30-0300 firmware.
These can be distinguished from the normal 30-0334s by checking the menu on the gauges.
The 30-0334 will have a menu item listed as "Obd2". The 30-0300 has "CAn" in its place. If you gauge has the "CAn" menu item, contact AEM for a replacement. They know about this issue.