VE table dimensions

[skala308]

Good day. I am new to using HP Tuners and still fooling around trying to learn more how to use the Editor.
Saw on a Youtube video about changing the dimensions in the VE table. On right side of the box where = + X actions can be done was a % dimension. This dimension could change and now there is no dimension displayed and the % dimension does not return.

In the process, the whole VE table content was reduced by dividing with 100. Meaning value of 42 became 0.42 etc.
It does not allow for the table to be X by 100, due to a range limitation.

Also any tune file opened, the VE table values are all reduced by /100. I have uninstalled the VCM and did a re-install, but this did not solve the fault.

Any suggestion please.

[5FDP]

I think I get what your saying but maybe not.

Try right clicking the VE table, anywhere in the table and go down to units and change it back to percent.

[skala308]

Thanks, yes will solve the problem. Much appreciated.
Eric from Support sent me an Email.