Results 1 to 2 of 2

Thread: [B]Scanner will not graph logged parameter (fuel pressure)[/B]

  1. #1
    Tuner in Training
    Join Date
    Dec 2011
    Location
    Sanford, NC
    Posts
    23

    [B]Scanner will not graph logged parameter (fuel pressure)[/B]

    Hello! I have been trying to get my Scanner to graph my fuel pressure without any success. It is an external sensor connected to my MPVI Pro input #3. I have added the MPVI Pro #3 input to my channel lineup, and performed the correct transform (AEM 0-100psi) to get the correct psi reading. When datalogging, the log tracks fuel pressure just fine, but it will not show up on the graph.

    I'm sure I have just overlooked something, but for the life of me, I can't seem to figure this out. I have posted a couple of screenshots below, as well as added my channel config and log file.

    Thanks for the assist!

    21-05-15 08-06-47.hpl
    Scott Config-fuel pressure.Channels.xml
    Scanner 1.JPG
    Scanner 2.JPG

    2012 Camaro SS/RS, LS3, m6, Whipple 2.9L, custom cam, methanol
    2007 Avalanche, 5.3L "383", 4L60e, modifications on-going....

  2. #2
    Tuner in Training
    Join Date
    Dec 2011
    Location
    Sanford, NC
    Posts
    23
    Bump.

    2012 Camaro SS/RS, LS3, m6, Whipple 2.9L, custom cam, methanol
    2007 Avalanche, 5.3L "383", 4L60e, modifications on-going....