2002 Mustang GT with EEC-V, I have just installed FIC 775cc injectors. Updated the tune file using the provide injector data from FIC website. Unable to get the vehicle to run with just injector change.
I am looking for information on the fuel injector tables.
On these EEC-V computers what is the correct method of adjusting the injector multiplier tables?
injector multiplier tables.png
-Flow Rate Low Mult vs. Pressure
-Flow Rate High Mult vs. Pressure
-Breakpoint Mult vs. Pressure
-Comp Mult vs. Voltage
-Offset Mult vs. Pressure
Here are the stock values for each of those tables.
stock values.png
Flow Rate Low Mult vs. Pressure, Flow Rate High Mult vs. Pressure, Breakpoint Mult vs. Pressure are all the same as below.
Pressure Delta Mult
128 1.2250
60 1.2250
40 1
20 0.7070
0 0
0 0
Comp Mult vs. Voltage
V Multiplier
16 0.78125
14 0.78125
11 1.25
10 1.46875
8 3.1875
6 4.1875
0 4.1875
0 4.1875
0 4.1875
0 4.1875
0 4.1875
0 4.1875
Offset Mult vs. Pressure
Pressure Mult
128 1
0 1
0 1
0 1
0 1
0 1
0 1
Here is what I used for the base file for using the FIC 775cc injectors.
FIC values.png
https://fuelinjectorclinic.com/FORD-DATA/FORD-0775 - website link for the data
FICLINIC_775_FORDDATA_SCT_WEBSITE_RAILTEMP (1).xlsx
I feel like changing the row axis for each of the multiplier tables is causing this issue, as I can input the stock values for each multiplier tables and the car will run.
So what am I missing here?