Results 1 to 5 of 5

Thread: Disable Vats

  1. 10-21-2007 #1
    Doubledip
    Doubledip is offline
    Tuner Doubledip's Avatar
    Join Date
    Apr 2007
    Location
    Sydney, Australia
    Posts
    161

    Disable Vats

    Quick question... is it possible to remove VATS from a L76 and LS2 PCM... aka E40 and E38 with HP Tuners
    Last edited by Doubledip; 10-21-2007 at 07:52 AM.
    Reply With Quote Reply With Quote
  2. 10-21-2007 #2
    EC_Tune
    EC_Tune is offline
    Супер Модератор EC_Tune's Avatar
    Join Date
    Apr 2003
    Location
    Almost 2000 feet.
    Posts
    7,876
    Should be in the O/S section of the GEN IV engines and you need to do a Write Entire when you disable VATS.
    Always Support Our Troops!
    Reply With Quote Reply With Quote
  3. 10-21-2007 #3
    Doubledip
    Doubledip is offline
    Tuner Doubledip's Avatar
    Join Date
    Apr 2007
    Location
    Sydney, Australia
    Posts
    161
    think i have found it... in a diffrent spot.. would just like to confirm it withthe gurus of the forums. Under OS has VATS1 and VATS 2.. just set them both to disable?
    Reply With Quote Reply With Quote
  4. 10-21-2007 #4
    Doubledip
    Doubledip is offline
    Tuner Doubledip's Avatar
    Join Date
    Apr 2007
    Location
    Sydney, Australia
    Posts
    161
    Thanks EC Tune

    already come unstuck with the Aussie Alloytec PCM this week .. was a little worried that the 6lt's would be the same
    Reply With Quote Reply With Quote
  5. 10-21-2007 #5
    EC_Tune
    EC_Tune is offline
    Супер Модератор EC_Tune's Avatar
    Join Date
    Apr 2003
    Location
    Almost 2000 feet.
    Posts
    7,876
    Your good to go.
    Always Support Our Troops!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »