how do you disable the rear o2 sensor for a cobalt ss sc 2.0?
how do you disable the rear o2 sensor for a cobalt ss sc 2.0?
You don't.
RSG Offroad
Jeeps. Jeeps. And more Jeeps. Oh and Jeeps too.
why does everyone say to turn off the rear o2 when they have problems with their aftermarket header
You can't turn it off.
You can change the PCM to disregard the MIL for certain codes, but it's still active.
RSG Offroad
Jeeps. Jeeps. And more Jeeps. Oh and Jeeps too.
if this is the case, when the rear o2's are disconnected will the computer try and over / under fuel?
if so how do you fix this?
thanks
Chris T.
2014 F350 6.7 Powerstroke.
2008 Ford F350 Super Duty 6.4L 72MM turbo
2007 Escalade 6.2L
2007 Yukon Denal 6.2L
2010 Lexus RX350 3.5L
2001 Tacoma 3.4
2000 Camaro SS LS1 M6 - STS Turbo
1998 Dodge Cummins 12v 5spd
1998 Topkick Cat 3126E 7.2L
1983 Toyota Pickup
1982 Toyota Pickup
2006 DRZ400
2008 Turbo Nytro
2010 Skidoo XP 800
1978 Corvette
The rear O2 sensor is not for fueling anyways, but to tell you if the cat is working or not. You can keep the CEL from coming ono for the rear O2 sensor.
I've got these codes after swapping out my header/dp.
P0030
P0053
P0134
P0135
P2A00
They all refer to oxygen sensor and heater control issues. Is it okay to disable all of them? My car drives great and idles fine, but I was shocked at how many codes modifying my exhaust threw up. I kept an aftermarket cat in the downpipe too.
2008 Cobalt Sport Coupe 2.4L A4
K&N Typhoon Ram Air Intake
CA 2.5" Header and Down-pipe w/ cat
If u remove the rear o2 from the harness disable all codes (set to no reporting and uncheck mil light) anythign having to do with bank 1 o2 sensor 2 and do the same for catalytic efficiency codes
I run it liek this on my redline...and pass obd2 emissions checks...on multiple cars
you can leave the rear o2 connected if you have the aftermarket cat and such there, might as well incase someone looks, so just disable those MIL's in the VCM and your good to go. basicailly the hi-flow cat isnt working as well as the factory restrictive unit would be (but it still works!) so your good to go.
.... did hpt start supporting 08 'balts when i wasnt looking? i think it only goes up to 2007 sooo... you cant disable the codes or anything, as far as i am aware, however you can get a rear O2 simulator. i have also heard of people getting some kind of boss that screws into the o2 boss in the exhaust, allowing the o2 sensor to be set back into it more, use two of them and the decreased amount of exhaust that gets to the sensor will make it read in a way that the vcm thinks its still operating 100%, even with the cat completley removed.
quick question about the o2 sensors. why does neither bank 1 sensor 1 or senor 2 not show up when scanning on these cars?