C6 A6 w/2800 Vigilante - Recommendations

[n77nxc]

Guys,

I installed a 2800 Vigilante into my 07 C6 A6. Is there anything I should change in my tune to accommodate the new torque converter. The car drives fine for the most part but I was wondering if there was anything I can do to get rid of some of the mushiness, for lack of a better word.

Any recommendations will be greatly appreciated.

Thanks!

[EC_Tune]

Bottom end mushiness is the converter when it is unlocked. Get the converter locked up at lower throttle and it should feel better.

[n77nxc]

Bottom end mushiness is the converter when it is unlocked. Get the converter locked up at lower throttle and it should feel better.

Which tables do I modify to lockup the converter at part throttle? Would it be best to post my tune?

Thanks for your help!

[EC_Tune]

TCC Apply/Release tables would be the ones you want to look at. Make sure you move them down in concert. So if you take off 5 MPH from Apply you also take off 5 MPH from Release.

[8850]

The converter will see more wear with the additional locking and unlocking. If that's not a consideration then do as EC_Tune recommends. I prefer mine not to lock until I reach OD gears and live with the higher rpm part throttle acceleration.

[EC_Tune]

^^^ True. Just depends on what you want though.

[n77nxc]

Thanks guys...I was away due to the Hurricane. I'm sure 8850 knows what I'm talking about.

[EC_Tune]

Glad you're OK!