Ahh, could it just be a software error that the x-axis of gain table says Mass Air Flow (g/sec)? My VE table is really driving me nuts, and the lean-tip in from transient fueling isn't helping.. Its a chicken or egg kinda issue..
I think my error would've been adjusting the calibration of the MAP sensor offset by -1.. 200 linear, 9 offset vs 200 linear, 10 offset. I noticed the other day that the baro was reading 103.. Now, it obviously reads 102.. and the baro readout apparently changes everything. This isn't really on topic to this thread.. I'm just trying to sort out why my VE table went to hell in a handbasket..