Secondary ve table whats it for?
This is the table used when the MAF sensor fails. It serves the same purpose as the primary, but more as a backup table when in speed density mode.Originally Posted by RunnWS7
Aaron
'03 Z06 Corvette - The Normal Stuff.....
EFI-101, EFI Advanced, EFILive-101, Variable Camshaft Tuning
EFI University Evangelist
If your SD tuning, changing the primary won't do anything because the PCM is running on the secondary table. If your sure the primary is correct, you can copy/paste just the kPa/RPM ranges needed to the secondary.Originally Posted by RunnWS7
Aaron
'03 Z06 Corvette - The Normal Stuff.....
EFI-101, EFI Advanced, EFILive-101, Variable Camshaft Tuning
EFI University Evangelist
if it appears in the editor then it is used.Originally Posted by RunnWS7
I count sheep in hex...
Originally Posted by RunnWS7
Any time the car is in speed density mode.
Unplug or disable your mass air meter and the PCM will be using the secondary VE table.
Aaron
'03 Z06 Corvette - The Normal Stuff.....
EFI-101, EFI Advanced, EFILive-101, Variable Camshaft Tuning
EFI University Evangelist
Yes.Originally Posted by RunnWS7
Aaron
'03 Z06 Corvette - The Normal Stuff.....
EFI-101, EFI Advanced, EFILive-101, Variable Camshaft Tuning
EFI University Evangelist