P0106

[gsegse]

Hi.. I have P106 code after upgrade from 00 to 02 OS.
I have no code before I upgrade, so do I have to check the map wires or tweak the tables of the map sensor in the att pic.
Mode:
TM M6 fast 92/92
Ms 4 cam
Siemens 60 lb
Ls6 motor with PRC stage 2.5

Thanks in advance

[robbyredneck]

had a similar problem and it reduced power. open the table up and try raising the max values a little bit. you may be exceeding the map value at any given cell due to your cam and intake. mine was due to the turbo making boost at low tps.

[fasthotrod]

P0106: Manifold Absolute Pressure (MAP) sensor signal not within predicted range for 2 seconds.
Inspect for:
- restrictions in the MAP sensor vacuum source
- MAP sensor seal missing or damaged
- vacuum hoses disconnected, lose, or incorrectly routed
- intake manifold leaks
- vacuum leaks at the throttle body

Seeing that you haven't made changes to the intake system when you flashed it, then I doubt that any of the conditions above have been met... therefore, what RobbyRedneck is saying makes sense... if the PCM is expecting the MAP sensor to be within a certain value and you have exceeded that value, then it would probably throw the code.

Was there a change in the MAP sensor from 2000 to 2002? I don't know for sure, but I'd certainly be looking in that direction. Good luck.

[gsegse]

Thanks guys for the respond , problem solved I just increased the low area and the code is gone .